A pile driver is the person who operates the pile driver! The pile driver consists of a pile hammer, pile frame and auxiliary equipment. The hammer is attached between two parallel vertical guide rods (commonly known as the gantry frame) at the front of the pile frame and is lift

Pile driver is the person who operates the pile driver! The pile driver consists of a pile hammer, pile frame and auxiliary equipment. The hammer is attached between two parallel vertical guide rods (commonly known as gantry ) at the front of the pile frame, and is lifted with hook . The pile frame is a steel tower, and the winch is installed behind the tower for lifting piles and pile hammers. There is a guide frame composed of two guide rods in front of the pile frame, which is used to control the driving direction so that the pile can be driven into the ground accurately according to the designed orientation. The basic technical parameters of the pile driver are the weight of the impact block, impact kinetic energy and impact frequency. According to the power source of pile movement, hammers can be divided into drop hammers, steam hammers , diesel hammers, hydraulic hammers , etc. This type of work is divided into three technical levels: elementary, intermediate and advanced.

Registration phone number: 151-8019-4452 (WeChat synchronization) Teacher Liu

Safety precautions for the photovoltaic hydraulic vibrating hammer vibration pile driver at work: When the vibration pile driver is working, there must be a dedicated person to direct it. Commanders and operators should check each other's signals before working. Work closely together. When the vibration starts, an electric bell or other means should be used to send a signal to notify people around to leave. The planes of the vibrating hammer and the pile cap, as well as the pile cap and the pipe column should be leveled, the connecting bolts should be tightened, and regular inspections should be made to see if they are loose.

Pile driver operation method: The pile driver must be directed by a commander. Commanders and operators must communicate well before work and cooperate closely during work. When starting work, first notify the surrounding personnel to leave. The planes of the pile driver and the pile cap, the pile cap and the pipe column (or pile) should be leveled, the connecting bolts should be tightened, and regular inspections should be made to see if there is any looseness. When starting the pile driver, gradually increase it from low speed to high speed. When the pile driver is working, always pay attention to the current and voltage on the control panel. If an abnormality occurs, the machine should be shut down immediately for inspection.