Accidents caused by reversing are endless. In fact, reversing is not that difficult. People always reverse based on their own intuition and concepts. The most common mistake is to only look at the rearview mirror. Old drivers are very experienced in judging road conditions and routes, but novices should be more careful and make a habit of checking the surroundings of the car and the reversing route when reversing.
The first, standardized parking method.
The advantage of this parking method is that it is stable. As long as each step is done in place, the parking process will basically be very smooth. The final position of the vehicle after parking can be said to fully comply with parking regulations. The specific operation process is as follows. First, adjust the direction of your own vehicle so that its body and the car in front of the parking space are parallel and about half a meter apart. Then lightly step on the accelerator to let the vehicle move forward slowly, and at the same time observe the reflector on the right side of your own vehicle.
When you find that the reflector is blocking the B-pillar of the vehicle in front of the parking space from the driver's seat, stop the car, then turn the steering wheel to the right and start to reverse slowly. During the process, pay attention to the angle between your own vehicle and the vehicle in front, and fine-tune the steering wheel to keep it at about 45 degrees. When looking from the driver's seat, after the car body behind the parking space is fully visible in the left rearview mirror, turn the steering wheel left and continue to reverse, and adjust the direction according to the distance between the vehicle and the car in front and behind, until the car body is completely straightened, and parking is complete.
The second method is to use the rearview mirror to observe.
Adjust the rearview mirror so that you can observe the tire on our right side and then reverse. When reversing, we should observe whether there are any obstacles around us. If not, we can continue to reverse. There are some. Then we need to adjust the direction before reversing. When we park the car until it is almost entering the parking space, we can adjust the steering wheel back and reverse. However, when reversing, don't just pay attention to the distance behind, but also pay attention to the distance on both sides to prevent the rearview mirror from scratching other people's cars.
Because technology is becoming more and more developed now, many people like to install a reversing image on the car to prevent the distance from the rear of the car from being misunderstood when reversing. Installing reversing image can easily observe the situation of the rear of the car. Here, there are usually three lines like above. We can normally reverse to the distance where we need to stop to the red line, because red is a warning line. Once it enters, it means that the car behind the object is very close.
