People who work as technicians. An appliance repair technician or handyman works in the kitchen with a broken dishwasher. Workers are replacing heating elements. ,People
(1) If the water inlet pipe in the washing machine is blocked during the washing process, the water will not enter the bucket normally. At this time, you can open the water inlet valve to clean it, or replace it with a new water inlet pipe. (2) If the water leakage is caused by detergent residue, it can be solved by adding an appropriate amount of laundry detergent. (3) If it is water leakage and electricity leakage caused by blockage of the drain port, you need to check and repair the drain port in time.
provides professional home appliance repair, home appliance cleaning, pipeline dredging, waterproof and leak repair and other door-to-door services
When the dehydrator works, the internal temperature of the motor will rise to above 80°C. At this time, you need to turn off the power supply and let the washing machine cool before turning on the machine; you can also put the clothes in a dehydration tube and run for a few minutes before taking them out; or put the clothes in water and soak for a few minutes before dehydration treatment, etc. to reduce the load on the motor and reduce the occurrence of motor heating. (4) In addition, the load on the motor can be reduced by adjusting the rotation speed and selecting low-range operation. (5) Finally, you can wipe the surface of the roller with a wet towel to cool down.
The water temperature is too low due to cold weather and other reasons, and it will also cause the washing machine to have an e3 fault light on (i.e. the e3 light flashes). This situation is generally caused by the low water temperature of tap water, so the temperature of tap water needs to be appropriately increased to solve this problem.
Insufficient water level is also the reason why the E1 indicator light of the washing machine is on. It is generally caused by the failure caused by the user not setting the water level line correctly (i.e., the E1 light flashes).
Solution: First, set the appropriate water level height value (usually 0.5 to 1.5 cm) according to the type and quantity of clothes, and then adjust it according to the operating steps in the instructions.
