Welded multi-wave compensator has good corrosion resistance
Install the welded multi-wave compensator at the top of the right rear pole and tighten the screws, and plug in the five-core power cord plug. The negative pressure gauge is installed on the left rear end engineer, just tighten the screws. According to the height of application, the welded multi-wave compensator ring-shaped support frame is fixed on the vertical rod guide slider, and the welded multi-wave compensator is placed on the support frame. The semi-circular clamp is used to fix the unchanged welding multi-wave compensator necks into the vertical rod guide slider. After closing, tighten the fixed screws. Pay attention to the vertical body of the reaction welding multi-wave compensator.
Welding multi-wave compensator
When installing a welding multi-wave compensator, try to clear it as much as possible, and wipe it with Vaseline at each joint to prevent the locking of the welding multi-wave compensator, and then apply mechanical pump grease to avoid steam leakage. Use cleaning solutions such as toluene or ethanol to clean the repaired surface. Generally, the total cleaning area is larger than the surface layer under maintenance. Only in this way can it be prevented from being contaminated by the environment again by the cleaning surface of the welding multi-wave compensator.
Welding Multi-wave Compensator Next, welding Multi-wave Compensator Repairing Glue is prepared in a balanced mud form, and then a suitable clamping force is adjusted according to the size of the repair part. When dispensing, the welding multi-wave compensator first wipes a small amount of repair agent evenly on the repaired parts of the machine and equipment until it is done in one direction when dispensing.
Welding multi-wave compensator
Welding multi-wave compensator
releases a certain working pressure on it to ensure that it is slugged. When it is slugged, try to dissolve the gas in the bubbles as much as possible. In this way, it can ensure that repair and the surface of the machine and equipment are inseparable. The temperature control of welding multi-wave compensator is also very critical in operation. Since some test samples will be damaged in a high-temperature natural environment, then when encountering such a situation, choose welding multi-wave compensator, because welding multi-wave compensator will operate within the rated temperature range.
and maintain the heat generated by the welding multi-wave compensator after running under rapid conditions, and maintains the heat generation of the welding multi-wave compensator after a certain temperature. Generally speaking, the temperature of these test samples can be maintained within 3-8°C. Naturally, the actual motor rotor standard value can be achieved is also related to the condition of the welding multi-wave compensator.
