Today, the tools used to clean the washing machine are used. One Phillips screwdriver plus a ten-mm hexagonal driver
Start disassembly - first disconnect the power supply, this is a safe way, after all, you don’t want to be powered up...[grin]
Then twist the water supply pipe down to facilitate the installation of the panel
and then remove the screws around the body, which are usually screws at the cross port.
0 After the screw is removed, turn the panel gently up. Put your hand lightly when turning it over to avoid breaking the line!
Then start to remove the roller protection plate. Also, use the
at the Phillips screw port and start to remove the pulsator. After prying open the cap on it, there is also a Phillips screw inside
After removing the screw, take out the pulsator plate. If you feel a little stuck, turn it a few times and take it out.
After taking out the pulsator plate, you must also remove the roller. Use a ten-mm hexagonal corner to remove the screws. There are four pieces in total, and there is also an gasket in the middle. Don’t lose it!
After unloading the screw, take out the drum and see the mud inside? This is the water left after washing clothes, and it settles over time!
It only took three months to accumulate so much mud without washing.
After cleaning the mud, dehydration procedure will drain the sewage, and finally disconnect the electricity and then install it back! Total 20 minutes [witness]