Only after undergoing renovation can we better understand the word "desperation".
I believe that when everyone first started to renovate, they made a naive and sincere wish: I hope that the renovation will go smoothly and be completed on schedule. As a result, various aspects of the decoration also teach you very sincerely what the skinny of reality is.
On many home sharing platforms, "suffocating moments during decoration" and "accident scenes during decoration" have become hot topics among netizens.
■ Live well, Yidou Tang platform related topics
Through complaints, on the one hand, they can slightly alleviate their depression after venting, on the other hand, it also serves as a "trap" warning for readers.
Come and experience the "suffocation" in decoration~
met an invisible foreman. The hidden project was stopped twice and three plumbers were replaced. In order to coordinate the progress and meet the schedule, carpentry and The electrician worked cross-cutting, and while the electrician was finishing, the carpenter sealed the suspended ceiling .
html’s 22-month concealed water and electricity project finally came to an end. However, on the day of acceptance, the electrician “had a sudden awakening” and discovered that the embedded track lights had not been installed before sealing the board.The carpenter and the electrician shirk responsibility from each other. The electrician refused to admit it and said he thought the track light was directly installed. The carpenter said he was only told that it had a flat roof. The foreman was not present during the whole process...
·Experience summary
① Track The lamp must be selected before hanging on the ceiling and connected with the carpentry.
② When doing cross-construction, you must pay more attention to coordination. Although everyone is responsible, once something goes wrong, everyone will blame each other.
netizen @张伊宝’s cabinets are custom-made for the whole house. Because all the details were checked with the designer in advance, I didn’t have to watch them on site when the cabinets were installed. After the
was installed, I went to open the cabinet door and take a look - the
drawer was perfectly blocked by the door hardware and could not be opened at all!
would like to ask the installer, after installation, did you try to open the cabinet door and pull out the drawer to check?
· Experience summary
During the decoration process, you must watch by yourself when installing anything, otherwise the probability of problems is too high.
@网友Oasis_Green Zhoujia kitchen ceiling is divided into two parts, one is above the range hood , and the other is above the sink. There is a beam between the two parts. The correct method is to use the beam as the separation, and the two parts are separated by a beam. Parts are suspended from the highest point.
However, because there was no on-site supervision, the ceiling master tried to save trouble and installed the ceiling above the sink along the height of the volume, two heights per kitchen.
It doesn’t matter if one is high and the other is low. The ceiling above the sink is even lower than the windows... and there is no way to install curtains.
I bought a second-hand house and simply renovated it. I painted the walls, replaced the window and door covers, and installed baseboards . I gave these tasks to a decoration company.
After the wall paint was painted, I went to inspect it. My dear, the wall painter only painted the areas he could see -
There was a plastic bag in the gap between the heating pipe and the wall. The master only needed to bend down and move the plastic bag away. , but he didn’t, and the area blocked by the plastic bag was not painted with wall paint;
had agreed with the decoration company in advance to remove the old lights on the roof, and then painted the wall again, but the result was no success. As a result, after the replacement, the old lights were exposed on the roof. The part of the wall that was not painted after the lamp was removed.
I have always dreamed of taking a bath comfortably at home. I have heard that there are many pitfalls when installing a bathtub, so when decorating, I also carefully built a bathroom with a bathtub. When choosing a master,
specifically chose a master who charges a flat fee. It is said that he has rich experience and is very popular . When
was accepted, at first glance I felt that the money given to the master was quite worth it.
When I took a closer look, my mood suddenly dropped to the bottom - there was a gap (deep) of about 3cm on the edge of the bathtub.
went to find the master, and the master said there was nothing he could do.
Because the kitchen cabinets in my home were not designed according to common sense, I designed an open cabinet without doors for the upper cabinet. It was this open cabinet that had to be reworked three times before it was installed successfully.
For the first time, the master who customized the whole house did not consider the top line treatment of the open cabinet at all, causing the cabinet to protrude than the cabinet next to it↓
finally convinced the master to rework, forgetting that the door panel from the top to the top is higher than the inner frame , the open cabinet is equivalent to the height of the inner frame, and there must be a section above it.
So for the second time, the open cabinet was shorter than the cabinet next to it↓
For the third time, after avoiding the pitfalls of the previous two times, the open cabinet finally looked perfect.
Did you think it was over?
NO! The master of
said that the middle door panel of is deformed and the manufacturer needs to redo .
After the kitchen sink was installed, I found that the water drop point was seriously deviated from the center of the sink and very close to the outer wall of the sink, making it very easy for water to splash out.
If we want to change it now, we can only move the water pipe back, but this will leave traces of the original holes on the countertop, which is ugly. If
is not changed, the water flow will be larger and the water will splash out, which is very difficult to use.
is now soliciting a good solution from the entire network.
extremely narrow door and window frames have stronger lines, which can make doors and windows visually lighter. It can also be regarded as a popular "Internet celebrity decoration" recently.
Therefore, netizen @小满精品版 plans to renovate the heavy door frame in his home and arrange the extremely narrow door frame. In order to cater to this trend,
aluminum alloy door frame customization merchants can even make door and window frame covers only 1cm thick, which is indeed much narrower than the traditional 2.5cm aluminum alloy door frame.
then excitedly ordered aluminum alloy doors, windows, and frames at the local building materials market, and then the "nightmare" began - when
installed the kitchen door frame, he did not use a level to calibrate it, resulting in the final door frame being slanted, and the outside was all left to the later stage. The carpenter and the latex paint master leveled it, and the problem of the interior not sticking to the wall could not be solved; after the
frames were installed, there were still large and small gaps between the wall and the wall. The installation master did not mention the matter of gluing at all, and took the initiative to ask for it. Glue, the merchant replied that it is okay to come again, but there will be an additional charge.
In the end, he asked the window installer to help with glue and sealing. While doing the glue, he complained that the door and window seller was too unreasonable, and the gap was too big, and the glass glue could not cover it...
It was the third time to renovate the whole house, and there were many pitfalls. I tried my best to avoid it, but an unexpected rollover accident still occurred. When
installed the floor heating equipment, he drilled the electric drill from the kitchen wall. As a result, he drilled through the wall directly.
The newly installed bathroom tiles were gloriously "disfigured".
You can tell me it's a coincidence, but this brick is just under the glass brick and is difficult to replace. You may have to spend money to repair the tiles in the end.
Because of the minimalist feeling, netizen @kindergartenxiaobanzhangzi chose a very narrow metal skirting line that was partially inserted into the gap in the floor, with 2.5 cm exposed on the surface.
Then we encountered the biggest pitfall on the road to decoration -
The lower end of the skirting line needs to be inserted under the floor, but the gaps in some places are not big enough and cannot be installed;
■ To install this kind of skirting line, you need to install it between the floor and the wall. There are suitable gaps between
The tiles need to be installed with skirting. Only part of the skirting can be cut off, but the contact surface of the cut skirting is not enough and there is no way to fix it;
The skirting is too narrow and cannot be cleaned daily. Be very careful when mopping the floor, as you can stain the wall in minutes if you are not careful.
finally replaced the 2.5cm skirting with a 4cm one.
■In actual use, the visual difference between the 4cm skirting and the 2.5cm skirting is not very big, but it is much more practical.
Have you had any other rollover accidents during decoration? Feel free to speak out and "suffocate" together.
