After taking the driving license test, many people are not confident enough to drive on the road. Especially when I go to a certain place and have to reverse and park my car, I feel a little guilty at first. Reversing not only tests one's driving skills, but also tests the driver's thinking ability, ability to deal with things, and the observation and judgment of the eyes. Today, we will talk about the three most common reversing situations, so unskilled drivers can learn about them.
1. The most common parallel parking spaces in parking lots.
Drive the car forward two parking spaces. The position you are sitting in the car is exactly in the middle of the second parking space, keeping a distance of 1.5m from the parking space line. After grasping the position of the rear and rear of the car, parking is done.
2. Common tandem parking spaces on the roadside.
First park the car 50 centimeters to the left of the car in front, and then reverse the car. At this time, you can correct the distance between the two cars;
Reversing When entering, when the outside right rearview mirror of the vehicle you are driving is on the same level as the B-pillar of the vehicle in front (that is, the pillar where the driver's seat belt is installed), turn the steering wheel full to the right and continue to reverse. When the car and the vehicle in front are at an angle of 45 degrees, turn the steering wheel full to the left to park the vehicle smoothly into the parking space. If the vehicle position is slightly off after entering the parking space, you can correct the position forward and backward.
3, slash parking space, this is also relatively common.
First determine the parking space you are entering and the direction;
When you see the left rearview mirror aligned with the left edge of the parking space, turn the steering wheel full to the right and continue moving forward.
When the car body is in a straight line with the parking space, stop the car and look at the left and right sides. Pay attention to the equal distance from the cars on both sides. It should not be too close to one side, which will affect getting on and off the car. Align the wheels and reverse slowly. During the reversing process, the distance between the vehicles can be corrected and the vehicle can move smoothly into position.
Common mistakes in backing up the warehouse
1. During the process of reversing the vehicle, if the vehicle is parked in place, there will be no voice prompt; but when the system prompts to stop midway before it is in place, please do not drive the car forward at this time, otherwise you will directly fail the course. Therefore, when the student is reversing, if there is a voice prompt to stop midway, this time You have to keep reverse gear until the car is in place. This will only deduct 5 points for stopping in the middle.
2. Inaccurate point grasp
. During daily practice, you must pay attention to your sitting posture, and consciously adjust the seat and rearview mirror after getting in the car; make sure that the points seen through the rearview mirror are the same as those seen during practice at the driving school.
3. The direction will not be adjusted when the warehouse is reversed.
The principle of adjusting the direction is to observe which side is wider and which side to hit.
4. The operation lasts for more than 210 seconds.
Students cannot be decisive when operating the steering wheel, and there are factors such as insufficient vehicle speed control. When reversing the vehicle and parking the steering wheel, it is better to operate the steering wheel earlier than too late, otherwise it will be difficult to adjust.
5. Poor vehicle speed control
When reversing into a parking lot, the slower the better. Even if you look wrong, you still have time to adjust. During the test, students must control the clutch and the speed of the vehicle.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-