1. Installation preparation (1) First, check the model and quality of the toilet. After confirming that there are no problems, manually select the part quantity and prepare the installation kit. (2) Conduct actual inspection, plan the installation location, decide on the implemen

1. Installation preparation

(1) First, check the model and quality of the toilet. After confirming that there are no problems, manually select the part quantity and prepare the installation kit.

　(2) Conduct actual inspection, plan the installation location, decide on the implementation plan, measure the required dimensions, and make arrangements.

　(3) After aligning the drain outlet on the ground with the drain outlet at the bottom of the toilet, draw the position of the bottom corner of the toilet, fix the hole on the ground, and use an impact drill to drill to a depth of about 5 cm.

　2.

　3.

　IV. Parts fixing and testing

　(1) Prepare to install other toilet accessories and the float in the water tank. After opening the water inlet valve, adjust the float height of the float and the water spray size of the water spray valve, and adjust the tightness of the control screw according to the required water inlet height of the water tank.

　(2) After the water tank is filled with water, check whether each pipe joint is leaking. If not, seal the gap between the toilet base and the floor with putty or silicone.

　(3) Install the toilet seat and toilet cover, turn on the water source and test the water. If the water flow is normal, please clean it and use it normally.