Some beauticians often encounter requests from owners to make "flat seams" when making epoxy colored sand. Can epoxy colored sand really make flat seams? Are there any technical requirements?
Epoxy colored sand flat seam is to make the epoxy colored sand beautiful seam basically flush with the ceramic tile surface. This flat seam technology can avoid dust depositing in the gap and facilitate cleaning.
If you want to use epoxy colored sand, you must pay attention to these three points:
① Correct construction tools
It is recommended to choose a rubber trowel or beef tendon scraper for epoxy colored sand construction, which has hardness and a certain elasticity.
② The construction technique is correct.
If you want to make a flat seam, you need to fill it fully with the material. The scraper squeezes the filler and collects the material at an angle to make the material fill fuller.
③ The correct wiping time
Generally start scrubbing in 5-10 minutes when the temperature is above 35℃, try to finish wiping the filled gaps in about 15 minutes; when the temperature is below 10℃, start scrubbing within 30-45 minutes. When wiping for the first time, try to drain the water in the sponge as much as possible. Don't leave too much water, otherwise the colored sand in the gaps will be brought out and the flat seam effect will not be achieved.
If you want to make flat seams, construction operations are very important!
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-