It is best to choose cuttings from June to July. The climate is suitable, the internal activity of rubber tree branches is high, and the success rate is higher. The cutting method is as follows;
Cuttings: Choose strong annual branches as cuttings, each section is 12-15 cm long. Can.
Prepare pot soil: The substrate used must be soft, breathable, and fertile, and it must be disinfected before use.
Put the cuttings into the soil; dip the cuttings in rooting powder , insert them directly into the soil, and water them thoroughly.
Post-management: Provide a warm, ventilated and cool environment.
1. Cutting time
Rubber trees like to grow in a warm environment. Judging from its growth habits, spring and summer are the peak growth seasons every year. It is best to make cuttings at this time. The internal activity of the branches is high, the environment is suitable, and it is convenient to make cuttings. Management can promote rooting and survival as soon as possible. The specific time is between June and July.
2. Cutting method
Cutting cuttings: The branches used for cutting should be cut from strong and strong rubber trees. Annual ones will do. Each section is about 12-15 cm long. After cutting, place the cuttings in a ventilated, well-ventilated place. Let dry in the shade. If the upper leaves are wide, it is best to cut them in half to reduce water and nutrient consumption, which will facilitate rooting.
Prepare pot soil: The soil used for cuttings must be soft, breathable, and rich in nutrients. When preparing, you can mix vermiculite , humus soil , garden soil, perlite , and stir evenly. It needs to be disinfected before use. You can disinfect it by exposing it to strong light or using a disinfectant solution to avoid bacteria or insect eggs inside.
Cutting into the soil: The rubber tree cuttings have been processed and the cuttings can be carried out after the substrate is prepared. Dip rooting powder at the bottom of the branch, poke a few small holes with a wooden stick on the surface of the substrate, then place the cuttings into the holes and compact the surrounding soil. After cutting, water must be poured thoroughly in time to allow the substrate and cuttings to absorb sufficient moisture. If the temperature is low, cover it with plastic film to keep it warm.
Later management: If you want to propagate rubber trees by cuttings from , they will have a higher maturity rate and faster rooting, so you need to strengthen management after cuttings. It is best to control the temperature between 20-25°C and sprinkle water frequently to ensure that the substrate is moist. Don't rush to bask in the sun, just put it in a well-ventilated and cool environment. In this environment, it will take about half a month to take root and survive. After rooting is confirmed, fertilizer and water management should be strengthened, and the light should be gradually increased and exposed to more sun to promote faster germination and more vigorous growth of the cuttings.
