All parts are in sufficient stock
Omega , Rolex , Cartier , Piaget and other movement parts include crowns, mirrors, bracelets, links, etc.; also include waterproof rings, automatic rotors, gears , hairspring, and spring can all be replaced. Some parts need to be replaced because it takes too long or there are no original parts for special models. It is possible to renovate or repair the old parts and repair them, or to make them from scratch.
Although the watch segment is only part of the bracelet, it will also directly affect the wearing experience of the watch wearer. If you wear a watch frequently, the watch segments may be scratched or damaged due to bumps or falls, and in serious cases they need to be replaced; but the most important problem is that the fixing pins between the various watch segments will gradually wear out over time. Falling off can easily cause the watch to fall or be lost, which requires regular inspection and replacement of new fixing pins.
Although the hardness of the sapphire watch mirror is second only to diamond , it is very brittle, especially when it is hit or vibrated by external forces, which can easily cause the watch mirror to be scratched, damaged or cracked; stop the watch in time and turn the watch back. Dai sent it to a watch repair center for repair.
After many years of watches without any maintenance, the store often receives watch repairs from brands such as Omega and Rolex. The reasons are mostly: water in the watch (rust on the crown), excessive winding force (the crown is pulled out, But it cannot be installed), frequent winding (no threads in the crown), etc., can all be repaired.
When the watch is used daily, problems are more likely to occur when the clasp is frequently opened and closed. 1. The buckle is easily deformed by pulling hard. 2. The "little tongue" on the buckle is broken; of course, the nails or screws between the metal buckle and the watch section are easier to escape or back off, which requires Replace and inspect regularly.
Movement parts are damaged due to watch knocks, waterproofing failure, violent vibrations, lack of maintenance, etc. Damaged watch parts that are often accepted in the store, such as waterproof rings, automatic rotors, springs, gears, etc., will be replaced after inspection by the master. Replace worn parts.
The battery of the quartz watch needs to be replaced about once every 1-2 years to avoid battery leakage, which may cause the circuit board to break and the movement to be corroded. The inner coil, crystal oscillator, motor and other parts of the quartz movement also need to be replaced due to long-term use. If it is damaged due to operation without maintenance, it does not require regular maintenance like a mechanical watch, and the movement parts must be cleaned regularly.
