has been playing ChatGPT recently, so he has no time to write. But I will still check the comments from fans. One of the fans said that
is very interesting. Generally speaking, for the sake of engineering installation speed, the network cable usually only peels off the outer sheath, and the outer skin of the internal core wire is not peeled off. In most scenarios, the connection between the network cable and the terminal is completed by punctured by the core of the network cable core wire. Here, whether it is a wire tweaker as a module or a wire tweaker as a crystal head , it is almost the same.
reply to netizens' information that the core inside the crystal head is not good, or the outer skin of the network cable core is incorrect, which will lead to poor contact problems in this step, which will make the network speed unstable.
Simply put, it is not punctured with the outer skin of the core wire.
replied halfway, and I remembered it. I mentioned before that
First, pure copper is easily oxidized when exposed to air. The formation of an oxide layer will cause line failure. This is especially important for the spare network cables that are not often inserted into the network interface for a long time.
Secondly, the plug with nickel plated and gold plated does not make much sense. The conductivity of copper is 1.9, and the conductivity of nickel is 50. It is better not to plate this thing on the ferrule. The basically thin layer of gold cannot solve the real corrosion problem.
The best material for this ferrule is phosphor bronze . It has sufficient strength to penetrate the core skin, and it also has sufficient durability and conduction characteristics.
I just want to reply to the previous fan comments, but I just want to disassemble a crystal head for everyone to show it.
happens to have an internet cable at home that I don’t know what to buy. Just take this network cable to perform surgery:
There is no trick to remove the ferrule from the prepared network cable, just cut it a little bit at the back of the ferrule.
Then use a needle to pick it forward on the back and you can remove the ferrule. When I took it out, I saw that the bottom of the sieve was silver. I'm still thinking, this thing seems to be craftsmanship, so I take a piece of sponge sandpaper to make it appear coppery. I polished it for a long time and didn't move until...
There is another reason for the poor Internet speed. No matter whether you have a Class 6 cable or a Class 5 cable or your Internet speed is not good, you have to verify whether there are 8 iron pieces in your crystal head.
Iron-piece core with aluminum-clad copper mesh cable, can you say you are a monster with a monster, right?
So the advice I can give you is that when you buy a new crystal head in the future, don’t rush to drive the network cable first. Remove a few pieces first, use to absorb iron stone to see if it is an iron sheet. If it is really an iron sheet, there is no need to spend time to draw the wire.
#Telebrity Creation Challenge#
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-