is very rare speakers with passive/active frequency-dividing input terminals at the same time
Human perception is standardized by big data
In the 18th century, when human beings started to enter the industrial society, it once led the world audio industry after the mid-20th century, and the music industry reached the glorious era of Hundred Schools of Contest . Although it has lost to globalization, caused by a few chaebols monopolizing media and markets, consumers perceived "standardized" in the wave of . Those audio fun that respects the individual consciousness of players and gives users more free space is still in some British manufacturers to this day. The product is kept online with
0 Tianlang TANNOY speakers that insist on keeping the dual-wire bi-wire input terminals
Many friends should find that in order to encourage users to use dual-wire bi-wire connections to improve equipment performance, almost all British brands, whether it is affordable to high-priced speakers and amplifiers, are equipped with dual-wire bi-wire terminals
The first set of speakers in high school The dual-wire bi-wire terminal for va-100 configuration
LINN flagship mono rear-level professional dual-wire terminal for
TANNOY speaker connected with dual-wire
B&W speaker connected with dual-wire
Dual-wire 9 terminal This seemingly unnecessary and cost-effective configuration is actually a thoughtful design that early manufacturers are willing to consider from the perspective of players, and it is nothing more than allowing users to obtain less cost. More elasticity of equipment performance
For the introduction of the principle of dual-wire bi-wire , please refer to:
Tianlang TANNOY speaker
the most wasteful audio accessories in history
the most wasteful audio accessories in history - fever speaker jumper
fever speaker jumper This can be said to be the most wasteful audio accessories in in the sense , and its existence value is not only to satisfy the superficial possessiveness and superiority ht In addition to ml6, the function is just like buying an SUV equipped with 4WD. After the result, the transmission function became 2WD. In this way, the so-called fever "stripping strip" is replaced by the original drive shaft ridiculous
fever speaker jumper . This ultimate loss of the bank function logic, for all accessories installed on the audio circuit, it can definitely be listed as the first of the audio accessories.
high-priced single-wire speaker cable + noble fever jumper-the most loss of the bank
In fact, friends who have a little knowledge of electronic and electrical engineering should know that only two pairs are needed. The " most ordinary " speaker cable is connected in the double-wire bi-wire way. The improvement of the electrical performance of single-wire speaker cable + noble fever jumper effect , a simpler metaphor is like driving into a one-way tunnel or a two-way tunnel difference
that is, the effect of using two most ordinary speaker cables will greatly exceed a single high-priced speaker cable
double-wire is like driving into a one-way tunnel, whether it is QQ or Porsche 911 is not affected by the traffic lights, wind pressure, road conditions, accidents (feedback current) in opposite directions
double-wire is like driving into a one-way tunnel
single-wire single-wire is like driving into a two-way tunnel, any interference caused by the opposite lane will not vary depending on the level of the car being driven
single-wire is like driving into a two-way tunnel
subsequently, more secrets that the editor-in-chief and merchants are unwilling to let you know...
