When you meet an unreliable master, you will be really angry when you get a decorative decoration. The bathroom floor tiles have just been laid. In order to show the slope of the ground, the master poured two large basins of water directly. Now, the gaps in the floor tiles are full of water. If you want to make beautiful seams, it will not be enough to wait for a few months. It is too wasteful. I really can't listen to the master's whole next time I decorate!
This is the real experience of netizens. Now there is too much water in the gaps in the floor tiles in the bathroom, and it is muddy when it is cleared. The bathroom was originally not very ventilated. If it takes several months to wait until it naturally dry, now you can only use the vacuum cleaner to suck it, and use putty powder to absorb water. You must first clean the water stored in the gaps in the floor tiles, and then let the gaps dry naturally. It will be faster with a hot air gun.
(Photo source @南机文免娱乐)
Some people are curious why water use in decoration causes water to be in the gaps in the floor tiles?
Generally, after we lay the floor tiles, we do not make beautiful joints in time. The water flows to the ground and finally seeps into the gaps in the tiles. The indoor space is particularly wet, and the moisture cannot evaporate in a short period of time, which will cause this situation to occur. If the water in the gaps in the floor tiles are not cleaned, start to beautify the seams, which can easily cause the water to remain, and will become hollow over time, which will be more troublesome.
So can the floor tiles beautify the seams immediately after laying them?
is not allowed. It takes a week to lay the floor tiles before they can be beautiful. The specific time depends on the dryness of the cement mortar of the floor tiles. Simply put, it is necessary to ensure that the gaps in the floor tiles are clean and dry. Never wait until the paint is finished before starting.
Don't use water during the drying week, otherwise it will not only extend the time of seam beauty, but also add a lot of trouble. Be sure to check the worker's use of water. Don't easily enter the next stage after seam beauty, otherwise you will get a bathroom with alkaline and seam beauty peeling.
How do you determine whether the water in the gap is dry before doing the beautiful seam? The following two methods of are simple and effective, and you can judge them yourself.
1. Use tissues, can fold the tissues and stuck them in the gaps in the floor tiles, take them out after a while, and if there is no change, it will be fine.
2. Look at the dust, Use a utility knife to scrape the gaps in the floor tiles. If the dust scraped out is dry, it means that the gap has completely dried and you can do the seam.
It will be understood after installing the room once. Don’t think that beautiful sewing is small, and don’t think that everything will be fine if you apply a protective film. If the operation is not done properly, it will not be visible in a short time, and it will not be necessary for a long time. Don’t step on this pitfall again!
(The picture is from the Internet, please delete if infringes)
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-