For most people, since there is no concept of surface-installed radiators, they actually pay little attention to the purchase of this type of radiator. However, today the editor of Tianjin radiator will introduce to you the most popular light-drain pipe radiators on the market. L

For most people, since there is no concept of surface-mounted radiator , they actually pay little attention to the purchase of this type of radiator. However, today the editor of Tianjin radiator will introduce to you the most popular light pipe radiator on the market. Let’s take a look at the difference between them.

light discharge pipe radiator is composed of a base and a radiator discharge pipe. It mainly uses the thermal conductivity and fluid pressure difference of the radiator discharge pipe to quickly suck hot air into the radiator discharge pipe, causing the cold air to expand in the inner cavity of the pipe wall, and then through the circulation of the pipeline system, the hot air is constantly heated in the pipe, and the heat is discharged from the discharge pipe to the room. Therefore, the radiator discharge pipe can be divided into two types: hot water pipe and heat dissipation branch pipe. A hot water pipe (also known as a cold drain) is characterized by dissipating heat from the end of the hot water pipe or hot steel pipe to the room and the discharge pipe is filled with the heat required for air flow. If you want to use a light drain pipe radiator, clean the radiator drain pipe before use.

drain the water from the light drain pipe radiator into the system for cleaning. Do not let the water go away first. Leave a part of it as the water quality for the circulating pipeline system. However, due to the different materials of the radiator discharge pipes, the requirements for water quality are also different, and water quality is not suitable for use even if it is too acidic or too alkaline. The water should be added gradually to the water from the inside to the outside using a soft hose. When adding salts, alkaline detergents, corrosion inhibitors, , etc. as media, stir evenly before adding salts and soaking until the water quality meets the prescribed requirements. In order to prevent the corrosion of salts and alkaline water on radiator , chemical substances such as chlorine can be treated.

should not be too long each time, and it is recommended to control it to 15-20 minutes. During the flushing process of the entire system, if there is a poor water flow, a drain valve can be added at the outlet to prevent the water flow from impacting too much. Until the outlet water flows smoothly.