In order to make household water cleaner and hygienic, many people now choose to install pre-filter . However, the plan was not done before installation, which caused constant trouble in the future.
suggests that if you want to install a pre-filter, you must do the following 4 things in advance to avoid leaving hidden dangers.
①The installation time should not be too early
Some owners want to save trouble, and in the water and electricity transformation stage, let the master install a pre-filter. seems to save money, but in fact it is causing trouble for themselves. pre-filter is exposed outside, and dust and debris will inevitably fall out during construction, and even collisions will occur, which will greatly affect the performance of the pre-filter.
More importantly, in the later stage of hydropower transformation, the pressure test is needed. During pressure, the water pressure is generally around 6-10 kg (1 MPa). Most pre-filters cannot carry high-intensity water pressure. If you don’t pay attention, It is easy to cause explosion accidents , and this loss is not a little bit.
Recommendation:
Pre-filter installation time needs to be considered in accordance with the specific installation location:
1. Installed in the kitchen, usually after the water pressure test is completed, l2 cabinet installation pre-filter
2, install in pipeline well , you can wait until the interior decoration is basically completed before installing the filter.
②The installation direction cannot be reversed
The pre-filter generally has arrow indications. Under normal circumstances, the arrow should correspond to the direction of the entry. The installation order is: water meter - pre-filter - water pipe in the house. Don’t turn the direction in the opposite direction, it will be a waste of money!
③The installation height should not be too low
The pre-filter is too low from the ground, which may affect subsequent use. Especially the front filter installed in the kitchen, the position is too low, so it will be very troublesome to install the cabinet later.
Recommendation:
Generally speaking, the pre-filter should be at least 40 cm away from the ground, which will not affect construction and facilitate future cleaning.
④ Before installation, please consult the property
intends to install the pre-filter in the pipeline well, and be sure to consult the property in advance whether it can be installed.
Some community properties stipulate that it is not allowed to install filter devices privately. On the one hand, it is for the protection of the owner's rights and interests, and on the other hand, it is for security reasons. must be aware of the situation in advance to avoid unnecessary disputes.
(The picture is from the Internet, delete it immediately if there is any infringement)
