Yes, it’s the legendary bushi camera used to record whether passers-by fart. [View] 1. Introduction to a simple thermal imaging camera made using AMG8833. Equipped with an SD card slot, you can store the photos taken to the SD card.

Yes, it is the legendary camera (bushi) used to film whether passers-by fart. [See]

1. Introduction

is a simple thermal imaging camera made using AMG8833. Equipped with an SD card slot, you can store the photos taken to the SD card.

2. Shooting samples

3. Design drawing

schematic diagram

pcb diagram

4. Features

• has the measurement function of maximum temperature, minimum temperature, average temperature and core temperature ;
• lithium battery power supply and charging management function;
• Battery and power display;
• supports saving the current photo to the SD card;
• uses AMG8833 finished module with a resolution of 8x8. Increase the resolution to 64x64 through the interpolation algorithm;
• supports iron red , "white hot" and rainbow three color cards;

5. Some points to note

• screen screen select the common 128x160 resolution, 1.8-inch ST7735S controller A small LCD screen module is sufficient, remember to choose the 14Pin plug-in type. The general price is between 10 and 15 yuan;
• battery should pay attention to the size and thickness, and it is not recommended to exceed 30x20x6mm;
• crystal oscillator does not need to be soldered (because precise timing is not needed);
• is the picture of Yile, look at the hot zone, Just take some photos of the deep well ice. Don’t have too high expectations for accuracy; if there are problems when
• is produced, check the welding first. 90% of the problems are caused by welding problems. It is possible that is even soldered to , is soldered falsely, or has the wrong component soldered. . Check it carefully and re-solder it together if necessary;

6. Physical pictures (6 pictures)